Monday, May 30, 2011
Modif Otak Atik Motor Honda Blade 110R 2011
To modify this time focus to the bottom Hobda Blade'll appear more vivid and macho, To modifkasi on the side of the wheel. The size of the front and rear 2.5-inch X17 6 × 17 inches. 110R honda motor blade is certainly reasonable to moge capacity 1300 cc. But how to get into in the duck is only 110 cc? The first step, of course, looking for swing arm that can be filled with edge width of 6 inches before.
You can use a variety of arms to the Ninja 250R for this modification honda motor. But of course can not directly attach. The problem dimensions that are too long arms, so if you maintain the standard mounting position would look very aneh.Oleh because it by sliding the mounting sleeve on the front. Because of course not possible to cut the previous extension arm. Created a new base of solid iron, so that the front is currently stuck with a machine. The design or form a new holder is to follow its original form.
Once the arm is attached, no more obstacles in the rear. As for the front rim as well as much broader than the standard, it must be a new triangle. iron with a thickness of 15 mm. Contrived to rim width can go.
MotoGP tail because this theme refers to the style of racing so make the body design that refers to any process of change in motor MotoGP.Maka also to the rear frame. Cut about 10 cm in order to form good.
The following data modifications Honda Blade 110R:
Front tire: 120/60-17 Bridgestone
Rear tire: 200/55-17 Bridgestone
Airs next: LHK
Sok back: Jupiter MX 135LC
Caliper: 4 piston Kitaco
Muffler: Replication CBR1000
X-16: (021) 65861510
And here are other ideas for modification of Blade 110R honda motor
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment